DR Power 6.0 HP Pro Power Wagon (June 2002 - January 2007) - Manual (Page 16)

16 POWERWAGON
™
Safety & Operating Instructions
Changing the Oil
Change the oil as directed by your engine
manufacturer's owner's manual.
Tools & Supplies Needed:
• 3/8" ratchet and extension
• 3/4" socket
• adjustable wrench
• SAE30 HD motor oil
• suitable container for old oil
• rag or cloth
!
WARNING: Always disconnect the
spark plug wire before servicing your
machine.
1. Remove the oil drain plug from the
bottom of the engine (Figure 10) and
drain the oil.
2. Replace the plug and refill the oil to
the level indicated on the dipstick. Do
not overfill.
To Replace the Belt
!
WARNING: Always disconnect the
spark plug wire before servicing your
machine.
1. Position the machine on a level surface.
Set the parking brake.
2. Tip the bed forward.
3. Remove the cinder blocks. (Pg. 23)
4. Pull on the idler pulley and spring to
lessen the tension on the belt and slide
the belt from the idler pulley
(Figure 11).
5. Remove the belt from the transmission
pulley at the front of the machine
(Figure 12).
6. Remove the belt from the clutch pulley
under the engine (Figure 10).
7. Install the new belt on the clutch pulley
first, then the transmission pulley and
then the idler pulley. Make sure the
new belt is INSIDE the belt guide near
the clutch pulley (Figure 10).
8. Reinstall the cinder blocks and the
weight rack block strap to secure them.
Figure 10
Figure 11
Figure 12