beautypg.com

DR Power Power Tiller Cultipacker Roto-Hog User Manual

Page 8

background image

8

DR

®

ROTO-HOG™ POWER TILLER - OPTIONAL ACCESSORIES

9. Slide the Impeller Shaft through the hole in Spreader Screen and insert the

Agitator Hairpin thru the center hole in the Impeller Shaft (Figure 8).

10. Position the Motor Mount assembly with the Spreader Screen into the

Hopper and slide the Impeller Shaft through the hole in the bottom of the
Hopper (Figure 9). Secure the Spreader Screen into the recessed portion of
the Hopper by sliding the edge of the Screen under the Clips on both sides.

11. Line up the Motor Mount Bracket with holes in Hopper. Secure Motor

Mount Bracket to Hopper with two 5/16-18 x 1" Hex Bolts, two 5/16"
Washers, two Nylon Washers (against outside of Hopper) and two 5/16"
Nylon Locknuts (1/2" Wrench) (Figure 10).

12. Slide the Spreader Impeller onto the Impeller Shaft with the large fins facing

up and secure with 1/8" x 1-1/4" Cotter Pin (Figure 11).

Figure 9

Spreader
Screen

Motor Mount
Assembly

Impeller
Shaft

Clip

Hopper

Figure 10

Hopper

Motor Mount
Bracket

Bolt, Washer,
Nylon Washer
and Nylock
Nut

Figure 11

Impeller
Shaft

Spreader
Impeller

Cotter Pin

Figure 8

Agitator
Hairpin

Impeller
Shaft

Spreader
Screen

This manual is related to the following products: