DR Power Power Tiller Cultipacker Roto-Hog - Manual (Page 7)

Contact us at www.DRpower.com 7
2. Position the left hand Mounting Bracket onto the back face of Tiller Fender
(Figure 4), with mounting tabs facing in, and replace the hardware you
removed in step 1. Install a 5/16-18 X 1” Hex Head Bolt (on top), Washer
and Nylon Locknut (1/2" Wrench) to secure the Bracket to top of the Tiller
Fender. Repeat this step to install the right hand Mounting Bracket.
3. Use the top and bottom holes of the Mounting Tubes on the Hopper/Frame
assembly to attach the assembly to the Spreader Mount Brackets with four
5/16-18 x 1-3/4" Carriage Bolts (1/2" Wrench), four 5/16" Washers and four
Wing Knobs (Figure 5). Make sure that the Carriage Bolt square goes fully
into the square holes of the Spreader Mount Brackets and the Wing Knobs
and Washers are on the Mounting Tube side.
4. Remove two 1/4" Nylon Locknuts (7/16" Wrench) from the Hopper
Assembly and position the two Angle Brackets and secure (hand tight) with
the two Nuts you removed (Figure 6).
5. Position the Rear Deflector onto the Angle Brackets and secure with two 1/4-
20 x 3/4" Bolts, Washers and Nylon Locknuts.
6. Tighten the Nylon Locknuts that secure the Angle Brackets to the Hopper
Assembly.
7. Position the Impeller Coupler over the Output Shaft of the Motor Mount
Assembly and secure with 1/8" x 1-1/4" Cotter Pin (Figure 7).
NOTE: The Impeller Shaft has three holes in it. It should be mounted so that the
center hole is furthest away from the Impeller Coupler.
8. Insert the Impeller Shaft into the Impeller Coupler and secure with 1/8" x 1-
1/4" Cotter Pin.
Hex Head Bolt,
Washers and
Nylock Nut
Figure 4
Tiller Fender
Mounting
Bracket
Mounting
Tab
Wing Knobs
and Washers
Figure 5
Hopper
Assembly
Carriage
Bolts
Hopper
Mounting
Tubes
Nylock
Nut
Figure 6
Hopper
Assembly
Angle
Bracket
Bolt,
Washer and
Nylock Nut
Rear
Deflector
Figure 7
Impeller
Shaft
Cotter
Pins
Output
Shaft
Impeller
Coupler
Motor Mount
Assembly