DR Power Power Tiller Cultipacker Roto-Hog - Manual (Page 17)

Contact us at www.DRpower.com 17
Chapter 5: Troubleshooting Your Optional Accessory
Most problems are easy to fix. Consult the Troubleshooting Tables below for common problems and their solutions. If the
procedures for fixes are not in your OPTIONAL ACCESSORIES Safety and Operating Instructions or if you continue to experience
problems, please feel free to contact our Customer Service Representatives at our toll free number 1-800-DR-OWNER (376-9637).
TROUBLESHOOTING YOUR DR POWER SPREADER
Troubleshooting Table
TROUBLESHOOTING YOUR DR CULTI-PACKER
Troubleshooting Table
S YMPTOM P OSSIBLE C AUSE
Hopper closure plate does not open to the correct
position. ⇒ Material packed around plate. Clean out around closure plate.
Spreader motor doesn't run. ⇒ Loose connection in spreader wiring. Check and reconnect.
⇒ Loose battery connection. Tighten battery terminals.
⇒ Battery is run down. Recharge the battery.
⇒ Broken spreader wiring. Replace damaged wiring.
⇒ Spreader on-off switch is broken. Replace the switch.
⇒ Spreader motor is broken. Repair or replace motor.
Motor runs when switch is shut off. ⇒ Spreader on-off switch is broken. Replace the switch.
S YMPTOM P OSSIBLE C AUSE
Culti-packer wheels do not turn when in use. ⇒ Material packed around wheels. Clean out around and between wheels
Culti-packer does not raise and lower when the
tiller control panel is operated. ⇒ Check that the culti-packer handle assembly is locked in the desired
groove. Lock the handle assembly into the desired groove.
The culti-packer does not touch the ground when
in operation. ⇒ The culti-packer is in the transport position. Move the culti-packer into
the operating position.
When performing any maintenance on the DR Spreader Attachment when the unit is still attached to the tiller, you must first make
sure the switch on the tiller control box is in the “off” position and then disconnect the wire harness of the motor mount assembly.