DR Power Power Tiller Cultipacker Roto-Hog - Manual (Page 11)

Contact us at www.DRpower.com 11
17
18
6
5
3
2
4 20
Hardware Package Contents
The item numbers on the illustration and in the table below are the same item numbers listed in the parts list and schematic
diagram in the “Parts List and Schematic Diagrams” section of chapter 7. This reference will aid in the proper location of parts as
you assemble and install the Culti-packer.
Assembling the Culti-packer
Tools Needed:
• Two 3/4" Wrenches
1. Position the Hook Assembly with the Adjustment Slots facing down and line
up the mounting holes with the Frame Assembly (Figure 18).
2. Insert the Bolts, Washers and Spacers (bolt heads facing out) and secure
with the Locknuts using two 3/4" Wrenches.
Installing the Culti-packer
1. Rotate the ROTO-HOG Power Tiller Wheels to their halfway position with the
ROTO-HOG Control Box (Figure 19).
2. Position the Culti-packer at the rear of the Tiller near the wheel axle (Figure
20).
3. Rotate the Hook Assembly away from the Tiller.
ITEM NO. QTY. DESCRIPTION
17 2 Extension Spring
18 2 “S” Hook
6 2 Hairpin Clip
5 2 Clevis Pin
2 2 Bolt, Hex, 1/2" X 1-3/4"
3 2 Washer, .5312" X 1.5" X .1345"
4 2 Nut, Nylon Lock, 1/2"
Bolt and
Washer
Locknut
Frame
Assembly
Spacer
Transport
Hook
Adjustment
Slots
Figure 18
Figure 19
Set at
approx.
45°
ROTO-HOG
Power Tiller
Figure 20
Transport
Hook
Tiller