DR Power Walk-Behind Pro (2000 - 2001) - Manual (Page 16)

DR
®
TRIMMER/MOWER
™
Assembly & Operating Instructions 10
Starting & Operating
Electric-Starting
1. Push the throttle lever on the left side
of the handlebar (Figure 16) all the
way forward to the START position.
2. On the PRO model:
Prime the engine. Make sure you
completely cover the air hole. Push
the black primer bulb (Figure 17) for
three seconds and completely release
it, letting it pop back to its original
position. Repeat three to four times.
The Commercial model does not have
a primer.
Note: Priming is usually unnecessary
when restarting a warm engine. In
cool weather priming may need to be
repeated
.
3. Turn the key (Figures 17 & 18) to the
START position until the Trimmer
starts, then release. The key will snap
back to the RUN position.
Note: The key switch on the
Commercial model is located between
the engine and the shield on the left
side of the trimmer (Figure 18).
Manual-Starting
Can be used with both Manual- and
Electric-Starting models.
1. Push the throttle lever on the left side
of the handlebar (Figure 16) all the way forward to the START position.
Figure 17
Figure 18
WARNING!
THIS MACHINE IS SHIPPED WITHOUT OIL! TRACES OF OIL MAY BE IN RESERVOIR
FROM FACTORY TESTING, BUT YOU MUST ADD OIL BEFORE STARTING ENGINE.
FILL RESERVOIR SLOWLY, CHECKING DIPSTICK FREQUENTLY TO AVOID
OVERFILLING.