DNF Controls ST60-DVC - Manual (Page 3)

3 ST60-DVCPRO
THE ST60-DVC VTR CONTROLLER
The ST60-DVC VTR Controller is ideal for Television Stations, Cable TV, Video
Production, Video Post-production, Audio Post-production, Duplication Houses and
Corporate Video Facilities.
STANDARD FUNCTIONS
RECORD REWIND
PLAY FAST FORWARD
STOP EJECT
REAL-TIME STATUS INDICATORS (ACTIVE ON)
RECORD REWIND/REVERSE
PLAY FAST FORWARD/FORWARD
STOP/STILL
2. INSTALLATION
a.
Set the VTR's Data transfer rate to 9600 baud, No Parity, 8 bits, 1 stop bit.
Set ACK RETURN to off. See the DVCPRO User’s Manual.
b.
Plug the 9-pin connector end of an RS232 serial cable in to the 9-pin
female connector on the rear of the ST60. Plug the 25-pin connector end
of the same cable into the 25-pin female “RS232-C” remote connector on
the rear of the VTR. See wiring information below.
c.
Plug the POWER SUPPLY’s 9-pin connector into the 9-pin male
connector “POWER” on the rear of the ST60. Plug the other end of the
POWER SUPPLY into 90 VAC to 265 VAC.
d.
Select REMOTE operation on the VTR's front panel.
e.
Set the RECORD SELECTOR SWITCHES, located on the rear panel of
the S60, to the desired record mode per the "RECORD SELECTOR
CHART."
f. Set Dip Switch #6, on the rear panel, as follows:
ON AJ-D230, AG-5710
OFF AJ-D750, AJ-D640, & all others
Installation is completed.