DNF Controls ST420-PTV - Manual (Page 6)

ST420 –PTV Shotbox for ParkerVision Protocol 6
c. SELECT CAMERAS TO WORK WITH
1) Press [MENU] key.
3)
Press CAMERA SELECT switch.
4)
The LCD switches show the cameras from 1 to 16. The switches that show the
controlled cameras are Green. The switches that show inactive cameras are
Yellow.
5) Press the switches 1 – 16 to add/remove cameras to/from the set of controlled
cameras.
6) Press [ENTER] to save your selection.
7) Press [ESC] to leave the MENU mode.
Setup is complete.
5. LEARN / VIEW / EDIT A PRESET INTO A SWITCH
a.
Press [LEARN] key. The LED above the LEARN key turns on and the LCD keys turn
Yellow to indicate learn mode.
b.
Press a Bank Select key to select a bank to learn the switch into. (This step is not
necessary if the switch is on the currently selected bank.)
c. Press an LCD switch to save preset in.
d. The LCD switches show the cameras from 1 to 16. The switches that show the controlled
cameras are Yellow. The switches that show inactive cameras are Off.
e. Press the camera switches to add/remove a camera from the preset. Added cameras turn
Green.
f. Press [ENTER] to save camera information.
g. The LCD switches show the numeric keypad and the Preset Number is shown on the
right.
h. Enter Preset Number to Learn. Entering 0 for preset will clear that switch.
i.
Press [ENTER] to save Preset Number.
j.
The LCD switches show the alphabetic keypad.
k.
Enter the label for the switch. Use bank keys 0-9 to enter numbers.
l.
Press [ENTER] to complete the LEARN.
Press [ESC] at any time to abort Learn.