DNF Controls ST100 - Manual (Page 6)

4 4 ST100 VTR Controller
3. INSTALLATION
a.
Plug one end of a 9-conductor, RS422 serial cable into the 9-pin connector on the rear of
the ST100. Plug the other end of the cable into the 9-pin remote connector on the VTR.
b.
Plug the 9-pin D-female connector on the POWER SUPPLY into the male 9-pin
connector on the rear of the ST100.
Plug the AC connector into a wall outlet, 90 VAC - 265 VAC, 50-60 Hz.
c.
Select REMOTE operation on the VTR's front panel.
d.
Set the RECORD SELECTOR SWITCHES, located on the rear panel of the ST100, to
the desired record mode per the “RECORD SELECTOR CHART.”
Installation is completed.
NOTE: For AMPEX 1-inch and D2 VTRs, set VTR ID to 0001.
Connection Diagram
NOTE: Rack mount version shown with Optional User Supplied external GPI switch inputs and tally
outputs. Tabletop version uses the same connections.