Digi-Star GT460 - Manual (Page 37)

Setting Options
D.A.N 477 Settings:
Determines if the preset is loaded when unloading begins, default is OFF.
Every unloading cycle will use the loaded preset. See page 14.
• OFF – No preset active.
• STORED – Enter an amount for the maximum truck capacity
o Used every time no matter if different trucks with different
capacities are used.
• TRUCK – Enter an amount for each truck
o Used to enter a different preset amount depending on
each trucks capacity.
• PARTCP – Enter any amount
o Used if a less than full load is required.
To keep the 12VDC output signal deactivated during the unloading
process when any D.A.N. 477 setting is ON, press before starting
PTO.
12VDC Output Diagrams
The diagrams on the following pages show the functionality of the 12VDC
output when D.A.N 426 is set to SIG 12V. SIG 0V reverses the output.
D3804 GT460 AutoLog
2
Operators Manual 37