Diamondback Fitness 1100U - Manual (Page 7)

7
1100R Assembly Instructions
Rear Frame & Seat Assemblies
1. Unscrew two M8 x 20mm bolts from the rear stabilizer bar.
2. Assemble seat frame to seat track, making sure to adjust the seat tightening mechanism so it will not bind with
the seat track upon installation.
3. Install seat track assembly by sliding seat track onto seat track receptor. Securely fasten the seat track using
two M8 x 15mm screws and the seat track stop using two M8 x 20 mm screws and washers with a 5mm Allen
wrench. Take note that the seat track stops must be installed on the screws closest to the seat frame (see
diagram). Do not overtighten.
4. Place rear stabilizer bar under the seat track and align the screw
holes.
5. Insert and tighten two M8 x 20mm screws using a 5mm Allen
wrench.
6. Snap the seat track cover onto the sidecase of the seat track
receptor area.
7. Install the seat frame handlebar onto the seat frame using four
M8 x 15mm screws and washers using a 5mm Allen wrench.
8. Install seat pads onto the seat frame using four 1/4” x 5/8" screws
and washers (for each pad).
Console Mast Assembly
1. Run main wire harness through the console mast adapter/cover
and install the console mast adapter/cover onto sidecase.
2. Connect the main wiring harness to the wire snake and pull
through the top (pull until just tight, DO NOT PULL HARD!!) WIR-
ING HARNESS INSTALLATION HINT: Straighten the loops of
the wiring harness so that it can slide smoothly into the console
mast. Hold the bottom of the console mast next to the console
mast next to the console mast adapter/cover.
3. Install the console mast by sliding it onto the console mast re-
ceptor. Insert and tighten all four of the M8 x 55mm screws
using a 5mm Allen wrench through four holes of console mast
adapter/cover.
4. Cover screw holes of the console mast adapter/cover with four
screw access plugs.
Console Assembly
1. Connect the plug from the main wiring harness to the plug re-
ceptor on the backside of the console taking care to install cor-
rectly (see plug alignment marks). WIRING HARNESS INSTAL-
LATION HINT: Any excess wiring must be carefully inserted
(“stored”) back into the console mast before installing the con-
sole onto the console mast.
2. Fasten the console to the console mast with the four M5 x 12mm
screws and washers using a Phillips screwdriver.
Handlebar
1. Assemble the handlebar onto the mount and insert and tighten
the four M8 x 12mm bolts using a 5mm Allen wrench.
NOTE: The handlebar can be installed upside down. When in-
stalled properly, the hand grips align with the bottom of the con-
sole.
Pedals
1. Use a 15mm open-end wrench to firmly affix the pedals to the
cranks.
2. The left and right pedals are different and are denoted as right or
left on the bottom of each pedal. NOTE: Left pedal threads
counter-clockwise.
Waterbottle
1. Place the bottle holder on the console mast. Insert and tighten
the two spacers and two M5 x 35mm screws using a screw-
driver.