DFI G7L330-B - Manual (Page 39)

39
2
Hardware Installation
RJ45 LAN Port
The RJ45 LAN port is at location CN2 of the system board. LAN
allows the system board to connect to a local area network by
means of a network hub.
BIOS Setting
Configure the onboard LAN in the in the Integrated Peripherals
submenu (“Onboard Device” section) of the BIOS. Refer to chapter
3 for more information.
Driver Installation
Install the Realtek LAN Drivers. Refer to chapter 4 for more
information.
PXE LAN Boot ROM
If you cannot boot the SCSI hard drive from the SCSI add-in card,
you must change the default setting in the built-in PXE LAN boot
ROM. Please follow the steps below.
1. Type the and keys simultaneously when
prompted during system boot-up. The Realtek LAN boot screen
will appear.
2. The default setting in the Boot Order field is “INT 18h”. Press
the space bar to change the setting to “ROM Disable” then
press to save the setting.
W
LAN