DFI G7L330-B - Manual (Page 21)

21
2
Hardware Installation
Installing the DIMM
A DIMM simply snaps into a DIMM socket on the system board.
Pin 1 of the DIMM must correspond with Pin 1 of the socket.
1. Pull the “tabs” which are at the ends of the socket to the side.
2. Position the DIMM above the socket with the “notch” in the
module aligned with the “key” on the socket.
3. Seat the module ver tically into the socket. Make sure it is
completely seated. The tabs will hold the DIMM in place.
Pin 1
Notch
Key
Tab
Tab