DFI SR100-L20C - Manual (Page 67)

67
3
BIOS Setup
Any Key Press any key to power-on the system.
Keyboard 98 When this option is selected, press the “wake up”
key of the Windows
®
98 compatible keyboard to
power-on the system.
KB Power On Password
Move the cursor to this field and press . Enter your pass-
word. You can enter up to 5 characters. Type in exactly the same
password to confirm, then press .
The power button will not function once a keyboard password has
been set in this field. You must type the correct password to power-
on the system. If you forgot the password, power-off the system and
remove the battery. Wait for a few seconds and install it back be-
fore powering-on the system.
Hot Key Power On
This field is used to select a function key that you would like to use
to power-on the system.
Onboard Serial Port 1 and Onboard Serial Port 2
Auto The system will automatically select an I/O address
for the onboard serial port 1 and serial port 2.
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3 Allows you to
manually select an I/O address for the onboard se-
rial port 1 and serial port 2.
Disabled Disables the onboard serial port 1 and/or serial
port 2.