DFI SR100-L20C - Manual (Page 15)

2
15
Hardware Installation
Installing the DIM Module
Note:
The system board used in the following illustrations may not
resemble the actual one. These illustrations are for reference
only.
1. Make sure the PC and all other peripheral devices connected to
it has been powered down.
2. Disconnect all power cords and cables.
3. Locate the SODIMM socket on the system board.
4. Insert the module into the socket at an approximately 30 de-
grees angle. Note that the socket and module are both keyed,
which means the module can be plugged into the socket in only
one way.
5. To seat the module into the socket, apply firm even pressure to
each end of the module until it slips down into the socket. The
contact fingers on the edge of the module will almost completely
disappear inside the socket.