DFI SR100-L20C - Manual (Page 14)

2
14
Hardware Installation
LAN
USB 0
USB 1
1
r
BIOS Setting
Configure the system memory in the Chipset menu of the BIOS.
Refer to chapter 3 for more information.
System Memory
Warning:
When the DRAM Power LED lit red, it indicates that power is
present on the DIMM socket. Power-off the PC then unplug the
power cord prior to installing the memory module. Failure to do so
will cause severe damage to the motherboard and components.
Warning:
Electrostatic discharge (ESD) can damage your system board, proces-
sor, disk drives, add-in boards, and other components. Perform the
upgrade instruction procedures described at an ESD workstation only.
If such a station is not available, you can provide some ESD protec-
tion by wearing an antistatic wrist strap and attaching it to a metal
part of the system chassis. If a wrist strap is unavailable, establish
and maintain contact with the system chassis throughout any proce-
dures requiring ESD protection.
. .
. .
.
.
.
.
. .
. . .
.
.
.
The 90 o SODIMM
socket is located
beneath this area.
DRAM Power LED