DFI NP101-D16C - Manual (Page 40)

40
2
Hardware Installation
SDVO Connector
SDVOB_RED+
1 2
1 9 2 0
SDVOB_RED-
SDVOB_GREEN+
SDVOB_GREEN-
SDVOB_BLUE+
SDVOB_BLUE-
SDVOB_CLK+
SDVOB_CLK-
GND
GND
SDVO_INIT+
SDVO_INIT-
SDVO_FLDSTALL+
SDVO_FLDSTALL-
ENAVDD
ENABKL
SDVO_CLK
SDVO_DATA
PLT_RST-
5 V
The SDVO connector is used to install a DFI NP1-LVDS (24-bit / 2
channels external LVDS) or NP1-DVI (exter nal DVI-D)
daughterboard. These daughterboards come equipped with LVDS or
DVI interface allowing you to connect external display devices.
NP101-D16C comes standard with a BIOS that supports only the
NP1-DVI daughterboard.
If you intend to use the NP1-LVDS daughterboard, please take note
of the following:
1. It will not support the onboard LVDS.
2. A customized BIOS is required to suppor t the NP1-LVDS
daughterboard.
BIOS Setting
Configure the LCD panel in the Advanced Chipset Features
submenu of the BIOS. Refer to chapter 3 for more information.
X