Power-on select – DFI NP101-D16C User Manual

Page 22

Text mode
Original mode

Hardware Installation

Power-on Select

JP6 is used to select the method of powering on the system. If you
want the system to power-on whenever AC power comes in, set
JP6 pins 2 and 3 to On. If you want to use the power button, set
pins 1 and 2 to On.

When using JP6 “Power On” feature to power the system back on
after a power failure occurs, may not power on the system if the
power lost is resumed within 5 seconds (power flicker).

Note:
In order to ensure that power is resumed after a power failure
that may occur within a 5 second period, JP6 should be set to
pins 2-3 and the “PWRON After PWR-Fail” in CMOS is set to
“Power On”.

2-3 On:

Power-on via

AC power

1-2 On:

Power-on via

power button

(default)

JP6