Serial (com) port – DFI NP101-D16C User Manual
Page 28
28
2
Hardware Installation
Serial (COM) Port
The system board is equipped with an onboard serial port (COM
1). It is also equipped with a 9-pin connector (COM 2). These serial
por ts are RS-232 asynchronous communication por ts with
16C550A-compatible UARTs that can be used with modems, serial
printers, remote display terminals, and other serial devices.
Your COM port may come mounted on a card-edge bracket. Install
the card-edge bracket to an available slot at the rear of the system
chassis then insert the serial port cable to COM 2. Make sure the
colored stripe on the ribbon cable is aligned with pin 1 of COM 2. .
BIOS Setting
Configure the serial ports in the Integrated Peripherals submenu
(“Super IO Device” section) of the BIOS. Refer to chapter 3 for
more information.
COM 2
W
DCD- RD
1 2 3 4 5
TD DTR- GND
6 7 8 9
DSR- RTS- CTS-
RI-
COM 1
1
9
2
DCD-
TD
RD DTR-
GND RTS-
DSR- CTS-
RI-
W
- AR100-DR (112 pages)
- G7B630-N (127 pages)
- G7B630-N (154 pages)
- BT100 (71 pages)
- HR100-CRM (170 pages)
- BT103 (72 pages)
- BT161 (71 pages)
- CM100-C (70 pages)
- CD101-N (69 pages)
- CD102 Series (76 pages)
- CP100-NRM (150 pages)
- CR101-D (67 pages)
- CR100-CRM (177 pages)
- EL339-B (109 pages)
- G5C100-NR (160 pages)
- HD100-H81 (79 pages)
- HD101-H81 (83 pages)
- HD173-H81 (70 pages)
- HM100-QM87 (97 pages)
- HM103-QM87 (99 pages)
- HU103 (95 pages)
- KB161 (68 pages)
- HU173 (90 pages)
- LR100-N18M/N18S (126 pages)
- LR102-B18M (138 pages)
- EL630-NR (149 pages)
- SB102-D (60 pages)
- NP102-N16C (144 pages)
- MB630-CRM (171 pages)
- SB630-CRM (184 pages)
- SB630-CRM (183 pages)
- SR100-L20C (144 pages)
- SR100-N (152 pages)
- LT600-L (149 pages)
- G7B630-N (147 pages)
- CA331-P (131 pages)
- EL330-DR (142 pages)
- CP337-NRM (174 pages)
- HD310-Q87 (101 pages)
- EL620-C (192 pages)
- G7L630-B (133 pages)
- HD330-H81 (81 pages)
- HD330-Q87 (85 pages)
- HD332-H81 (76 pages)