DFI NP101-D16C - Manual (Page 15)

15
2
Hardware Installation
System Memory
Warning:
When the Standby LED lit red, it indicates that there is power on the
system board. Power-off the PC then unplug the power cord prior to
installing any devices. Failure to do so will cause severe damage to
the motherboard and components.
Warning:
Electrostatic discharge (ESD) can damage your system board, proces-
sor, disk drives, add-in boards, and other components. Perform the
upgrade instruction procedures described at an ESD workstation only.
If such a station is not available, you can provide some ESD protec-
tion by wearing an antistatic wrist strap and attaching it to a metal
part of the system chassis. If a wrist strap is unavailable, establish
and maintain contact with the system chassis throughout any proce-
dures requiring ESD protection.
. .
. .
.
.
.
.
. .
. . .
.
.
.
DIMM
Standby LED
The system board supports one 240-pin DDR2 DIMM socket.