DFI NP101-D16C - Manual (Page 31)

31
2
Hardware Installation
Universal Serial Bus Connectors
USB allows data exchange between your computer and a wide
range of simultaneously accessible external Plug and Play peripherals.
The system board is equipped with four onboard USB 2.0/1.1 ports.
The USB 4-5 and USB 6-7 connectors allow you to connect 4
additional USB 2.0/1.1 ports. The additional USB ports may be
mounted on a card-edge bracket. Install the card-edge bracket to an
available slot at the rear of the system chassis then insert the USB
port cables to a connector.
BIOS Setting
Configure the onboard USB in the Integrated Peripherals submenu
(“USB Device Setting” section) of the BIOS. Refer to chapter 3 for
more information.
W
W
USB 1
USB 0
USB 3
USB 2
1 0
9 1
VCC
-Data
+Data
GND
Key
VCC -Data +Data GND N.
C
.
2
USB 6-7
USB 4-5
W