DFI CD102 Series - Manual (Page 23)

www.dfi .com
23
Chapter 2 Hardware Installation
Chapter 2
RJ45 LAN Ports
The LAN ports allow the system board to connect to a local area network by means of a
network hub.
Driver Installation
Install the LAN drivers. Refer to chapter 4 for more information.
LAN 1
Features
• 2 Intel ® 82574L PCI Express Gigabit Ethernet controllers or 2 Intel ® WGI210AT PCI Ex-
press Gigabit Ethernet controllers (optional)
LAN 2
USB Ports
The USB device allows data exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
The system board is equipped with four onboard USB 2.0/1.1 ports (USB 0-1/2-3). The two
10-pin connectors allow you to connect four additional USB 2.0/1.1 ports (USB 4-5/6-7). The
additional USB ports may be mounted on a card-edge bracket. Install the card-edge bracket
to an available slot at the rear of the system chassis and then insert the USB port cables to a
connector.
BIOS Setting
Configure the onboard USB in the Advanced menu (“USB Configuration” submenu) of the
BIOS. Refer to chapter 3 for more information.
Driver Installation
You may need to install the proper drivers in your operating system to use the USB device.
Refer to your operating system’s manual or documentation for more information.
USB 2
10
VCC -Data +Data GND Ke
y
VCC
-Data +Data GND N. C.
9 1
2
USB 1
USB 0
USB 4-5
USB 2.0
USB 3
LAN 1
LAN 2
USB 6-7
USB 2.0