DFI CD102 Series - Manual (Page 18)

www.dfi .com
18
Chapter 2 Hardware Installation
Chapter 2
Digital I/O Power Select
JP16
2-3 On: +5V
1-2 On: +5V_standby
(default)
JP16 is used to select the power of DIO (Digital I/O) signal.
1 3 2
1 3 2
Digital I/O Output State
Based on the power level of DIO (Digital I/O) selected on JP16, JP17 (DIO pin 0-3) and JP18
(DIO pin 4-7) are used to select the state of DIO output: pull high or pull low. When selecting
pull high, the power selection will be the same as JP16’s setting.
2-3 On: GND
1-2 On: +5V or
+5V_standby
(default)
DIO 0-3
(JP17)
DIO 4-7
(JP18)
1 3 2
1 3 2