beautypg.com

Rear panel i/o ports, Chapter 2 rear panel i/o ports – DFI CD102 Series User Manual

Page 21

background image

www.dfi .com

21

Chapter 2 Hardware Installation

Chapter 2

Rear Panel I/O Ports

The rear panel I/O ports consist of the following:

• 1 12V DC-in jack (default) or 4-pin ATX power connector (optional)

• 1 HDMI port

• 1 VGA port

• 2 Serial COM ports

• 2 RJ45 LAN ports

• 4 USB 2.0/1.1 ports

• Line-in

jack

• Line-out

jack

• Mic-in

jack

COM 2

HDMI

USB 2.0

Line-out

Line-in

Mic-in

LAN 1

COM 1

VGA

LAN 2

DC-in

USB 2.0

12V DC-in (default)

DC-in

This jack provides maximum of 100W power and is considered a low power solution. Connect

a DC power cord to this jack. Use a power adapter with 12V DC output voltage. Using a volt-

age higher than the recommended one may fail to boot the system or cause damage to the

system board.

The 12V DC-in jack on the system board co-lays with a 4-pin power connector (optional) as

the figure displayed below.

DC-in jack

+12V Power

1 3

2 4

Ground

Ground

+12V

+12V