Dataprobe 4PK-SCS - Manual (Page 3)

Model 4PK-SCS Page 3
1) Port Selection
This selection connects the Master Port to any of the four ports A through D. This brings up a Port
Selection Menu. Each port can be given a 24 character name. The default names are shown below:
A) PORT A
B) PORT B
C) PORT C
D) PORT D
X) Exit
Enter Port >
Once a port is selected, the 4PK-SCS will clear the screen and generate the following message:
x Selected (x=the programmed name of the port)
Enter ESC{PASSWORD}ESC to return to menu
At this point the Master Port is connected through to the port selected. The 4PK-SCS is passive to the
messages sent between the Master Port and the port selected. To terminate the session with the
current port and bring back the menu, enter the escape character plus the security code and another
escape character. i.e.
E
s C
TEST
E
s C
2) Relay Control
This selection allows control of the relays in the 4PK-SCS.
1) Eng SWITCH1
2) Eng SWITCH2
3) Den SWITCH3
4) Eng SWITCH4
# - Select relay to toggle
P# - Pulse relay
X - Exit
Enter >
Again, each relay can be named. Eng and Den display the current status of the relay, Energized or
De-energized. To toggle the relay, simply enter the relay number, followed by Enter.
The relay can also be cycled (pulsed) by entering P plus the number. (i.e. P1 to cycle relay number 1)
The length of time the relay pulses is preset through the programming menu. While the relay is cycling,
a message will be displayed.