Daktronics Remote Control System RC-100 - Manual (Page 23)

RC-100 Handheld Controller 17
Setting Power Save Mode
Display Action
Press to modify the default LCD power on
when idle time. This is the amount of time (in minutes)
the wireless handheld will remain on when not in use.
Decrease this value for longer battery life. Increase this
value if the console needs to be inactive for longer
periods of time without turning off.
NN = Channel Idle Power On
Time in minutes
Default: 20 minutes
Use the number keys to edit the idle power on time.
Press when finished to save the new setting.
Connect Mode
Connect mode (Figure 12) is used when the wireless
handheld is connected to a wireless server Base Station.
In Connect mode, the wireless Base Station determines
the operation of the handheld, and all operation is
specific to the wireless Base Station Function selected.
Switching to Connect Mode
After all initialization and configuration is complete, the wireless handheld controller will be
ready to connect to a wireless Base Station.
Display Action
NN = Channel Setting
Press to create a connection to an
available wireless Base Station on the channel shown.
Note: The Wireless Base Station must be powered on
and must be set to the specified channel.

If a connection was made, the wireless handheld
will be operating in Connect mode. Refer to the
application-specific sections for operation details.

If a connection could not be made, refer to
Section 9 for information about how to resolve
the problem.
Figure 12: Connect Mode LCD Icon
PRESS ENT TO
SET PWR ON TI ME
I DLE PWR ON TI ME
CURRENT: NN*
I NI TI ALI ZI NG
RADI O
CONNECTI NG VI A
CHANNEL NN*