Daktronics Pro Series Quick Start Manual - Manual (Page 9)

SETUP
The Setup
module allows
Administrators the
ability to control
motors, to work
with limits and
calibrate i-batten
safety feature.
Limits are the
upper and lower
boundaries for
motor movement.
This module allows
the setting and
clearing of limits.
Change Motor
Touch the button
under Motor Select
to display the list
of motors. Touch a
motor name
to select.
Touch CONFIRM
or BATTEN SETUP
(see below).
Set Limits
Touch SET/CLEAR
LIMITS. Pick which
limit to change.
The keypad
will display the
boundaries. Enter the
target numerically
or use current batten
position.
Move Motor To Position
Touch MOVE TO
POSITION. Enter
target in keypad,
set speed and
touch MOVE.
The motor will
automatically move
to its target.
Move Motor Auto
Touch AUTO UP/
DOWN. Select a
location by touching
and holding its
button for three
seconds. The motor
will automatically
move to the location.
Move Motor Manually
Touch and hold the arrow
buttons. Slide your finger
to minus (-) to slow the
speed or plus (+) to
increase it. The
motor will stop
when the button
is released or
when the motor
has reached
its limit.
Change
Speed
Drag the
button left
or right, or
touch the
button twice
to enter the
speed.
Change Icon
Touch the icon button twice to display the Icon
Selection panel. Touch a category to display icons.
Touch an icon to select. Touch DONE to confirm.
Manage Icons
Select a category. To add an
icon to it, touch ADD. To delete
an icon, select one and touch
DELETE. Touch EDIT to display
category edit functions.
Add Category
Type a new name for the
category and touch ACCEPT. Edit Category
Touch CHANGE NAME
or CHANGE ICONS. Change Name
Type a new name and
touch ACCEPT. Change Icons
Select icons and touch
MOVE or DELETE.
Delete Category
Touch MOVE ICONS
or DELETE ICONS. Move Icons
Select category and
touch ACCEPT.
Delete Icons
Icons are deleted permanently from the system.
SE
TU
P
Batten Position Indicator
Indicates Upper & Lower Limit, as
well as current position of the batten.