Daktronics Pro Series Quick Start Manual - Manual (Page 6)

Keypad
Touch this
button
to enter
the target
numerically.
Delete
Select a preset by touching
its name. Touch ACCEPT to
remove the preset or touch
EXIT to leave this function.
Run
Select a preset by touching
its name. Touch ACCEPT
to choose the preset and
CONTINUE to confirm or
touch EXIT to leave this function.
After preset selection there are three options: START,
PAUSE and EXIT. Touch EXIT to return to the main menu.
Touch START to run the preset. The PAUSE and STOP/
CANCEL buttons activate. Touch PAUSE while running
to halt.
Touch STOP/CANCEL to
stop running the preset and
return to the main menu.
While the preset is paused,
touch START to continue
running the preset.
PRESETS
Name
Name your new preset by using the
VAC keyboard or the virtual keyboard.
Create
Select a motor and
move it using the
controls. This is the
motor’s target for the
preset. Repeat for all
motors.
Touch OMIT MOTOR
to ignore it in the list.
Touch ALL to add all
omitted motors back.
The motors will move
in the order of the
list. To change the
order, select a motor
and touch MOVE IN
LIST, and select a new
position.
When all motors are
in the correct position,
touch DONE.
Touch and hold the arrow
buttons to move the batten. Slide
your finger left or right to change
the speed.
Touch UPR for the upper limit, or
LWR for the lower.
Touch JOYSTICK for joystick
control. Touch the FINISHED
button to stop using the joystick.
Modify
Select a preset from
the list by touching
its name. Touch
ACCEPT to change
the preset or touch
EXIT to leave this
function.
After selection, this works like Create.
This module
works with
presets.
Presets are
single cues
that move
every selected
motor to a
set position
sequentially.
PR
ES
ET
S