Daktronics Pro Series Quick Start Manual - Manual (Page 8)

i-BATTEN RECOVERY
When the i-Batten fault screen
appears, don’t panic. The fault
screen displays when a motor
has an i-Batten fault while
running a cue or preset.
If you need to run a different
cue, hide the alert box and
then choose DIFF. CUE.
Display the alert screen when
you are able to clear the fault.
Hide/Show Alert
Touch the ALERT button or the three gold
arrows to hide or display the alert screen.
Clear Fault
Select a faulted motor. Touch CLEAR
FAULT. Adjust the sensitivity if necessary
or touch FINISH MOVE. This will clear
the current fault leaving i-Batten active.
Bypass
Select a motor. Touch BYPASS, CONFIRM and FINISH MOVE.
This will display an i-Batten Safety Off icon on actions
containing this motor and disable the i-Batten safety feature for
this motor.
NOTE: Once the i-Batten is bypassed it can only be enabled by
an Administrator using Batten Setup.
Disable
Select a faulted motor, then touch CONFIRM.
Cues with disable motors are displayed in red
text.
NOTE: Once a motor is disabled, it will not
move again and can only be enabled by an
Administrator using the Motor Restrict module.
CU
EI
N
G / i
-B
A
TT
EN R
EC
O
V
ER
Y
Delete
Select a cue to delete by
touching its name in the
cue sheet. If you make
a mistake, just touch the
correct one to change it.
Touch EXIT to return to the
main menu.
After the cue is selected,
touch DELETE to
permanently erase it.
Touch CANCEL CHOICE
to clear your selection.
Run
Select a
cue by
touching
its name
in the
list.
Touch SETUP to move the motors into
the starting position for the cue.
While the cue is running you may
stop it by touching PAUSE.
Touch ACCEPT to run.
Touch RUN CUE to start the cue.
Touch DIFF. CUE to change cues.
Touch RESUME to continue,
RESTART to set up the cue again.