Daktronics AF-3700-20 RGB - Manual (Page 34)

Start-up Procedure 24
5.2 Start-up Sequence
Each time the display is turned on, an initialization sequence will run. The information in the
second column will then be shown on the display.
Note: The Xs refer to numbers that may vary for each display, such as the hardware address.
Topic
Information shown
1. Product Name • GalaxyPro
2. Display Size • Row x Column
3. Shading • 16 mil
4. Bootloader Version • OS X.XX
5. Firmware Number • ED-16619
6. Firmware Revision • Rev X.XX
7. Hardware Address • HW:XX
8. Software Address • SW:XX
9. IP Address: • (default: IP: 172.16.192.25)
10. Subnet Msk: • (default) Msk: 255.255.0.0)
11. COM1 Configuration • C1:V15
(modem: C1:V15 if a modem is present)
12. COM 2 Configuration • C2: RTD
13. Socket 3001:
• IP 3001: V15
14. Socket 3002: • IP 3002: RTD
15. Line Frequency • CLK: AUTO (60)
16. Display Description • GalaxyPro # rows x # columns
After this sequence is complete, the display will blank. A single pixel will flash in the lower
right corner of the display to show that the display has power, but no messages are currently
running.