beautypg.com

8 structural inspection, 9 spare parts, Structural inspection – Daktronics Valo Digital Billboard User Manual

Page 36: Spare parts

background image

Routine Maintenance

28

To test the heater, turn the thermostat to the highest setting, typically 90° F.

• If the heater does not turn on, inspect the wiring and ensure the heater is connected.

• If the heater is connected, but not functioning, call the NOC at 1-877-DAK-HELP

(325-4357) to troubleshoot the issue or order a replacement heater.

To test the a/c unit, turn the thermostat to the lowest setting, typically 50° F.

• If the a/c does not turn on, inspect the wiring and ensure the a/c unit is connected.

• If the a/c unit is connected, but not functioning or cooling, call the NOC at 1-877-

DAK-HELP (325-4357) to troubleshoot the issue or order a replacement a/c unit.

Sometimes the heater or a/c can become disconnected from the power source. If you notice
this in a control cabinet, call the NOC at 1-877-DAK-HELP (325-4357) to help Daktronics
track the issue. Refer to the control cabinet Riser Diagram attached to the display door to
reconnect the heating and cooling equipment in the control cabinet.

6.8 Structural Inspection

Perform annual visual inspections of the display structure to facilitate repair and lengthen
display life.

• Check for possible corrosion, especially at structural tie points and ground rods.

• Check, tighten, and replace fasteners as required.

• Check electronic components for corrosion.

• At least once a year check the inside of the display for signs of water intrusion. Water

can enter the display where weather stripping has deteriorated or where fasteners
have loosened.

6.9 Spare Parts

The following table is a generic list of spare parts. Spare parts requirements vary for each
display. For a project-specific spare parts list, refer to the project Bill of Materials (BOM), or
for newer displays refer to the spare parts list on the inside of the spare parts box lid.

Part Number

Description

0A-1393-3005

Module; HD-16M AF-2114-20X24-RGB-REQ; DS-1604

TH-1116

Tool Box, Better Built 48 X 24D X 25H

0A-1335-2506

Assembly; Secondary Harness, 48"

W-1677

Cable Assembly; 20POS, 36", 28 AWG

W-1676

Cable Assembly; 20 POS, 25",28 AWG

0A-1413-0001

Assembly, Module PS, HK, Posi - Lock, A-2021R, 2 PIN

0P-1273-0039

MLC 4050' 8 Output, Coated

HS-1701

Padlock; Master Lock, Keyed Alike (11G043)

HS-1308

Weather-stripping, 1/16"T X 1"W, 50' ROLL