Daktronics Valo Digital Billboard - Manual (Page 29)

Replacing Display Components 21
• Various wrenches
• UV Rated Cable Ties
In most instances, a bucket truck is required to replace a webcam. To replace a webcam:
1. Locate the webcam signal connections on the display.
2. Remove the webcam power cable from the termination plate.
3. Remove the Ethernet cable from the termination plate.
4. Drill a 1 /
2
" hole for the new BNC coupler near the existing webcam signal cables.
5. Attach the BNC coupler to the display.
6. Remove the connection for the webcam power.
7. Replace the webcam power with the two-pin power connector.
8. Locate a half depth vertical location to mount the video server.
9. Hang the mounting plate on the half depth vertical with TEK screws.
10. Route the coaxial cable from the video server to the termination plate.
11. Connect Cable Input 1 on the video server to the new BNC coupler.
12. Connect the power cable to the adapter on the video server plate.
13. Connect the five-pin mate and lock end to the available five-pin jack on a power
supply.
14. Remove the Cat-5e cable from the jack within the display cabinet on the signal
termination plate.
15. Route and connect the Ethernet cable to the Ethernet input on the video server.
16. Locate and replace the existing transformer with the transformer located in the kit.
17. Reconnect the primary power to the transformer.
18. Route and connect the wire on the secondary side to the two-pin power connection.
19. Remove the old camera and existing camera cables.
20. Mount the Panasonic camera to the existing webcam arm.
21. Route the power and coaxial cables along the back of the display.
22. Connect the new power cable to the two-pin connector.