Daktronics Galaxy AF-3400 20 mm Monochrome/RGB Double-face Displays - Manual (Page 28)

Signal Installation 20
4.5 Ethernet Communication
If the communication system is Ethernet, look for:
• a network card in the computer connecting to a network switch.
• a network jack similar to an oversized phone jack.
Connections
• Computer to network − RJ45 cable from computer port to network server in building.
• Network switch/router to surge board at display − RJ45 cable from switch to surge board
in enclosure at display (maximum cable distance 300 feet).
• Enclosure at display to display − quick-connect cable from enclosure to middle jack on
side of display.
Troubleshooting
Component Check
Cable
Connections
•
The network cable connects the computer to the network switch/router.
•
An RJ45 cable from server is connected to the input jack on Ethernet surge
board.
•
The quick-connect cable runs from enclosure to middle jack on display side.
Display
Power
•
The display is either running a message or showing a single pixel flashing in
the bottom right corner of the display when power is on.
Software
•
The software is configured for TCP/IP communication.
•
The software and the display are set for the same network address.
•
Refer to the software manual for other possible conditions.
Figure 22: Ethernet Communication Layout