Daktronics Galaxy AF-3220 - Manual (Page 7)

Mechanical Installation 3
Section 2: Mechanical Installation
Daktronics’ engineering staff must approve any changes that may affect the weather-tightness of the display. If
any modifications are made, detailed drawings of the changes must be submitted to Daktronics for evaluation and
approval, or the warranty may be void.
2.1 Installation Guidelines
DO:
• Inspect the display for damage caused by shipping or uncrating
• Use all lift eyes when lifting the display maintaining 90 degrees between cabinet and lifting method
• Use all clip angles or bolt locations for mounting
• Leave adequate clearance for ventilation
• Ensure mounting location allows for door to pivot open
• Provide an adequate support structure that is straight and level
DON’T:
• Drill holes into the cabinet
• Modify the display without written approval from Daktronics Engineering
• Block intake vents on the bottom of the display
• Block exhaust hoods on back of display
• Use the lift eyes for permanent mounting
2.2 Support Structure Requirements
Daktronics is not responsible for installations or the structural integrity of support structures done by
others. The customer must ensure that a qualified structural engineer approves the mounting structure and
hardware.
Because every installation site is unique, no single procedure is approved by Daktronics for mounting
Galaxy
® displays. The information contained in this section is general information only and may or may not
be appropriate for this particular installation.