Section 1: introduction, 1 general pitch & speed information, 2 resources – Daktronics Radar Gun Speed of Pitch Interface User Manual
Page 7: Section 1, Introduction, General pitch & speed information, Resources

Introduction
1
Section 1:
Introduction
This manual explains the installation of several baseball speed of pitch systems. By connecting a
JUGS
radar gun to an All Sport
5000 control console, the user is able to output data to Daktronics
scoreboards, matrix display controllers (Venus
, Show Control), and the Daktronics Scoring-Timing
Interface (DSTI). This manual is not specific to a particular installation.
Important Safeguards:
Please read and understand all instructions before beginning the installation process.
Do not drop control equipment or allow it to get wet.
Do not disassemble control equipment; failure to follow this safeguard will make the
warranty null and void.
Disconnect display power when not in use or when servicing.
Disconnect display power before servicing power supplies to avoid electrical shock.
Power supplies run on high voltage and may cause physical injury if touched while
powered.
Project-specific information takes precedence over any other general information found in
this manual.
1.1 General Pitch & Speed Information
Section 5 of the All Sport 5000 control console manual (ED-11976) contains complete
instructions for operating the Pitch & Speed mode. Drawing A-130895 in Appendix A shows
the All Sport insert (LL-2482) used to operate this mode.
The manufacturers of the Jugs and Stalker radar guns also provide fully detailed operating
instructions in their respective manuals.
1.2 Resources
Figure 1 illustrates a Daktronics
drawing label. The drawing number is
located in the lower-right corner of a
drawing. This manual refers to
drawings by listing the last set of digits
and the letter preceding them. In the
example, the drawing would be
referred to as Drawing C-325405.
Reference Drawing:
System Riser Diagram ........................................................................... Drawing C-325405
Daktronics identifies manuals by the DD or ED number located on the cover page of each
manual. For example, this manual would be referred to as ED-12224.
Figure 1: Daktronics Drawing Label