Daktronics Radar Gun Speed of Pitch Interface - Manual (Page 17)

Radio Speed of Pitch Configurations 11
4. Connect the 1 /
4
" phone jack cable (W-1236) between the 1 /
4
" phone J-box and the
signal converter (0A-1065-0173). The cable is cut in half, and the other end is
connected to TB1 on the signal converter (red wire to 1 CL1+, black wire to 2 CL1-).
Plug the signal converter into a 120 VAC power source.
5. Connect the 9-pin to 9-pin cable (0A-1000-0121) between the J1 jack on the signal
converter and the 9-pin plug on the 30' (9 m) data cable (W-2453).
6. Connect the data cable to the 9-pin jack on the radar gun handle. The power adapter
(A-3010) may also be plugged into the handle and a 120/240 VAC power source, or
the gun may run off internal rechargeable batteries.
7. Ensure that any radar gun menu settings are properly configured for baseball.
Refer to the documentation included with the radar gun.
8. Plug in and power on the All Sport console. Ensure the radio broadcast and channel
settings are correct, and set to code “5500” to enter the Pitch & Speed mode.
Kit #3: Radar Gun Near All Sport – Radio Scoreboard & RS-232 RTD
In this configuration, the All Sport console receives speed-of-pitch information from a radar
gun that is located no more than 10' (3 m) away. The All Sport then transmits the radar data
directly to a scoreboard via wireless radio signal and to a Daktronics display controller via
wired RS-232 signal. Refer to the instructions below and Drawing B-159255 in Appendix A to
set up the system.
1. Connect the J4 end of the radar gun Y-cable (0A-1000-0123) to the J6 port on the back
of the All Sport console and the J1 end to the dual 25-pin J-box (0A-1166-0027).
2. Connect the JUGS end of the radar gun Y-cable to the 9-pin plug on the 30' (9 m) data
cable (W-2453).
3. Connect the data cable to the 9-pin jack on the radar gun handle. The power adapter
(A-3010) may also be plugged into the handle and a 120/240 VAC power source, or
the gun may run off internal rechargeable batteries.
4. Connect the 9-pin to 25-pin cable (W-1249) between the dual J-box and an available
serial (COM) port on the display controller or DSTI computer. The COM port must
be set to: 1200 baud, No parity, 8 bits, 1 stop bit, Standard RTD.
5. Ensure that any radar gun menu settings are properly configured for baseball.
Refer to the documentation included with the radar gun.
6. Plug in and power on the All Sport console. Ensure the radio broadcast and channel
settings are correct, and set to code “5500” to enter the Pitch & Speed mode.