Daktronics Radar Gun Speed of Pitch Interface - Manual (Page 12)

6 Speed of Pitch Wire Configurations
5. Connect the data cable to the 9-pin jack on the radar gun handle. The power adapter
(A-3010) may also be plugged into the handle and a 120/240 VAC power source, or
the gun may run off internal rechargeable batteries.
6. Ensure that any radar gun menu settings are properly configured for baseball.
Refer to the documentation included with the radar gun.
7. Plug in and power on the All Sport console, and set to code “5500” to enter the Pitch
& Speed mode.
Kit #2: Remote Radar Gun
– Current Loop Scoreboard & RS-232 RTD
In this configuration, the All Sport console receives speed-of-pitch information from a
remotely-located radar gun. The All Sport then transmits the radar data directly to a
scoreboard via current loop signal and to a Daktronics display controller via RS-232 signal.
Refer to the instructions below and Drawing B-130818 in Appendix A to set up the system.
1. Connect the 25-pin to 25-pin signal cable (W-1247) between the J6 port on the back of
the All Sport console and the dual 25-pin J-box (0A-1166-0027).
2. Connect the 9-pin to 25-pin signal cable (W-1249) from the dual J-box to an available
serial (COM) port on the display controller or DSTI computer. The COM port must
be set to 1200 baud, No parity, 8 bits, 1 stop bit, Standard RTD.
3. Route one-pair cable minimum (W-1077) from the dual 25-pin J-box to the
scoreboard, and another to a 1 /
4
" phone J-box (0A-1091-0227) near the radar gun.
Refer to the installation section of the scoreboard manual for signal connection
information.
4. Connect the 1 /
4
" phone jack cable (W-1236) between the 1 /
4
" phone J-box and the
signal converter (0A-1065-0173). The cable is cut in half, and the other end is
connected to TB1 on the signal converter (red wire to 1 CL1+, black wire to 2 CL1-).
Plug the signal converter into a 120 VAC power source.
5. Connect the 9-pin to 9-pin cable (0A-1000-0121) between the J1 jack on the signal
converter and the 9-pin plug on the 30' (9 m) data cable (W-2453).
6. Connect the data cable to the 9-pin jack on the radar gun handle. The power adapter
(A-3010) may also be plugged into the handle and a 120/240 VAC power source, or
the gun may run off internal rechargeable batteries.
7. Ensure that any radar gun menu settings are properly configured for baseball.
Refer to the documentation included with the radar gun.
8. Plug in and power on the All Sport console, and set to code “5500” to enter the Pitch
& Speed mode.