Daktronics Radar Gun Speed of Pitch Interface - Manual (Page 14)

8 Speed of Pitch Wire Configurations
5. Connect the 9-pin to 9-pin cable (W-1267) between the J1 jack on the signal converter
and an available serial (COM) port on the display controller or DSTI computer.
The COM port must be set to: 1200 baud, No parity, 8 bits, 1 stop bit, Standard RTD.
6. Route another one-pair cable minimum (W-1077) from the 25-pin J-box to the
scoreboard. Refer to the installation section of the scoreboard manual for signal
connection information.
7. Ensure that any radar gun menu settings are properly configured for baseball.
Refer to the documentation included with the radar gun.
8. Plug in and power on the All Sport console, and set to code “5500” to enter the Pitch
& Speed mode.