Daktronics Radar Gun Speed of Pitch Interface User Manual
Page 13

Speed of Pitch Wire Configurations
7
Kit #3: Radar Gun Near All Sport
– Current Loop Scoreboard & RS-232 RTD
In this configuration, the All Sport console receives speed-of-pitch information from a radar
gun that is located no more than 10' (3 m) away. The All Sport then transmits the radar data
directly to a scoreboard via current loop signal and to a Daktronics display controller via RS-
232 signal. Refer to the instructions below and Drawing B-130818 in Appendix A to set up
the system.
1. Connect the J4 end of the radar gun Y-cable (0A-1000-0123) to the J6 port on the back
of the All Sport console and the J1 end to the dual 25-pin J-box (0A-1166-0027).
2. Connect the JUGS end of the radar gun Y-cable to the 9-pin plug on the 30' (9 m) data
cable (W-2453).
3. Connect the data cable to the 9-pin jack on the radar gun handle. The power adapter
(A-3010) may also be plugged into the handle and a 120/240 VAC power source, or
the gun may run off internal rechargeable batteries.
4. Connect the 9-pin to 25-pin cable (W-1249) between the dual J-box and an available
serial (COM) port on the display controller or DSTI computer. The COM port must
be set to: 1200 baud, No parity, 8 bits, 1 stop bit, Standard RTD.
5. Route one-pair cable minimum (W-1077) from the dual 25-pin J-box to the
scoreboard. Refer to the installation section of the scoreboard manual for signal
connection information.
6. Ensure that any radar gun menu settings are properly configured for baseball.
Refer to the documentation included with the radar gun.
7. Plug in and power on the All Sport console, and set to code “5500” to enter the Pitch
& Speed mode.
Kit #4: Radar Gun Near All Sport
– Current Loop Scoreboard & RTD
In this configuration, the All Sport console receives speed-of-pitch information from a radar
gun that is located no more than 10' (3 m) away. The All Sport then transmits the radar data
directly to a scoreboard and to a Daktronics display controller via current loop signal.
Refer to the instructions below and Drawing B-130818 in Appendix A to set up the system.
1. Connect the J4 end of the radar gun Y-cable (0A-1000-0123) to the J6 port on the back
of the All Sport console and the J1 end to the 25-pin junction box (0A-1067-0056).
2. Connect the JUGS end of the radar gun Y-cable to the 9-pin plug on the 30' (9 m) data
cable (W-2453).
3. Connect the data cable to the 9-pin jack on the radar gun handle. The power adapter
(A-3010) may also be plugged into the handle and a 120/240 VAC power source, or
the gun may run off internal rechargeable batteries.
4. Route one-pair cable minimum (W-1077) from the 25-pin J-box to TB1 on the signal
converter (0A-1065-0173). Connect the red wire to 5 CL+ and the black wire to 6 CL-.
Plug the signal converter into a 120 VAC power source.