Daktronics Radar Gun Speed of Pitch Interface - Manual (Page 19)

Troubleshooting 13
Section 5: Troubleshooting
5.1 Troubleshooting
Setup for any of the speed of pitch configurations should produce few problems for installers.
However, if there are difficulties or if any component fails to operate, refer to the following
table for possible solutions.
Problem Possible Solution / Items to Check
All Sport is not receiving/
displaying data

Press the [SPEED •] key on the All Sport keypad to
manually display the speed. If this does not work, check
the wired signal cabling running to the display or wireless
radio settings on the radio receiver or All Sport console.
Refer to the scoreboard or display manual, or All Sport
5000 manual (ED-11976).

Check the All Sport menu and verify the correct gun
model is selected.

Check wiring between the gun and All Sport.

Check the gun for power and the communication
equipment (if applicable) at the gun location.
All Sport is receiving/
displaying data, but the
speed is too high/low by
a considerable amount
every once in awhile

Verify the radar gun is installed within the specifications
it requires.
Refer to radar gun manufacturer’s manual.
 Verify the radar gun’s menu settings are set correctly,
if applicable.
Refer to radar gun manufacturer’s manual.
 If there is a “once in awhile” high speed or low speed and
all other speeds are accurate, the gun maybe reading the
catcher’s throw back to the pitcher or other flying objects.
Use the All Sport Menu to set a Min. and Max. speed to
avoid displaying these type of readings. Refer to All Sport
5000 manual (ED-11976).
All Sport is receiving/
displaying data, but the
speed is consistently
slightly off (1-5 mph/kph)

Verify the radar gun is installed within the specifications
it requires.
Refer to radar gun manufacturer’s manual.
 Verify the radar gun’s menu settings are set correctly,
if applicable.
Refer to radar gun manufacturer’s manual.

Use Section 5.4 in All Sport 5000 manual (ED-11976)
along with Drawing A-243741 to calculate and enter a
speed adjustment/co-efficient so every speed sent to the
All Sport will be adjusted before being displayed.