Section 5: display maintenance, 1 digit/driver printed circuit board, Section 5 – Daktronics PC-2001 Pace Clock System User Manual
Page 25: Display maintenance, Digit/driver printed circuit board

Display Maintenance
19
Section 5:
Display Maintenance
IMPORTANT NOTES
:
1. Disconnect power before doing any repair work on the scoreboard.
2. Allow only qualified service personnel access to internal display electronics.
3. Disconnect power when not using the scoreboard.
5.1 Digit/Driver Printed Circuit Board
The PC-2001 uses a single printed circuit board (PCB) that contains all of the electronics
needed to make this system work: digit LEDs, control processors, power input connectors,
horn, and other components. All switches, power systems, and input/output terminations are
connected to the PCB.
As shown in Figure 9, the PCB is attached to the front panel of the display. Refer to Section
5.2 for instructions on accessing and replacing the PCB.
Battery
(BT-1014)
Nut securing signal jack
Screw
(HC-1489)
Case
Back
Circuit Board
(Part number varies
with model number)
Case
Front
Spacer
(HE-1357)
8-32 Nut
(HC-1354)
Figure 9: PC-2001 Exploded View
Rear Panel
Front Panel
Spacer (HE-1357)
Screw
(HC-1489)
8-32 Nut
(HC-1354)
Nut securing signal jack
Printed Circuit Board
(Indoor: 0P-1153-0001)
(Outdoor: 0P-1153-0003)
Battery
(BT-1014)