Daktronics MS-2013 Portable LED Scoreboard - Manual (Page 8)

2 Introduction
1.3 Resources
Figure 2 illustrates a Daktronics drawing
label. The drawing number is located in the
lower-right corner of a drawing. This
manual refers to drawings by listing the last
set of digits and the letter preceding them.
In the example, the drawing would be
referred to as Drawing C-1007804. Any
drawings referenced in a particular section
are listed at the beginning of it as shown below:
Reference Drawing:
System Riser Diagram ......................................................................................... C-1007804
Daktronics identifies manuals by the DD or ED number located on the cover page of each
manual. For example, this manual would be referred to as ED-13145.
1.4 Daktronics Nomenclature
Most components within this display carry a white label that lists
the part number of the unit. If a component is not found in the
Replacement Parts List in Section 6.7, use the label to order a
replacement. Figure 3 illustrates a typical label. The part number
is in bold.
Main Component Labels
Part Type Part Number
Individual circuit board 0P-XXXX-XXXX
Assembly; a collection of
circuit boards
0A-XXXX-XXXX
Wire or cable W-XXXX
Fuse F-XXXX
Transformer T-XXXX
Metal part M-XXX
Fabricated metal assembly 0S-XXXXXX
Specially ordered part
PR-XXXXX-X
Following the Replacement Parts List is the Daktronics Exchange Policy and the Repair &
Return Program. Refer to these instructions if replacing or repairing any display component.
1.5 Product Safety Approval
Daktronics outdoor scoreboards are ETL-listed, tested to CSA standards, and CE labeled.
Contact Daktronics with any questions regarding testing procedures.
Figure 2: Daktronics Drawing Label
Figure 3: Typical Label
Accessory Labels
Component Label
Termination block for
power or signal cable
TBXX
Grounding point EXX
Power or signal jack JXX
Power or signal plug
for the opposite jack
PXX