Daktronics MS-2013 Portable LED Scoreboard - Manual (Page 16)

10 Electrical Operation
4.4 Power-On Self-Test (POST)
The scoreboard performs a self-test each time that power is turned on and the control console
is powered off or not attached to the scoreboard. If the control console is attached and
powered on, the self-test does not run, and data from the control console is displayed on the
scoreboard after a brief period of time. Each scoreboard self-test pattern will vary depending
on the scoreboard model, the number of drivers, and types of digits. Figure 6 shows an
example of the LED bar test pattern that each digit performs.
Radio Settings
With an RC-100 base station installed, the channel settings (“C 01”) will be displayed in the
clock digits (Figure 7) during the POST. If an All Sport radio receiver is installed, both the
broadcast setting (“b1”) and the channel setting (“C1”) will be displayed. These values must
match the settings in the controller (refer to appropriate manual in Section 1.1).
Figure 6: Digit Segment POST
RC-100 (Channel) All Sport Radio (Broadcast & Channel)
Figure 7: Radio Settings
RADI O SETTI NGS
BCAST 1 CHAN 01 CONNECTI NG VI A
CHANNEL O1