Daktronics MS-2013 Portable LED Scoreboard - Manual (Page 25)

Scoreboard Troubleshooting 19
Problem Possible Cause Solution/Items to Check
Bad digit or driver
Exchange the digit/driver with a
working one of the same part # to
verify the problem. Replace if
necessary (see Section 6.3 for
digits or Section 6.4 for drivers).
Scoreboard works, but some
digits do not light
Bad digit or driver (see solution above)
Incorrect sport code (see solution on previous page)
Incorrect driver address (see solution on previous page)
Wrong console controlling
scoreboard
Another console’s radio signal could
be transmitting to the scoreboard.
An example would be football and
baseball scoreboards that are within
1500' (457 m) of each other.
Radio interference
There may be other radio
transmissions in the area that
overpower the console. If it is not
possible to disable the interfering
device, It may be necessary to run a
wired signal connection instead.
6.2 Component Location & Access
Reference Drawing:
Electrical Specifications, MS-2013 ........................................................................ A-159887
In the MS-2013, the entire back panel is hinged on the right side (as viewed from the rear). To
gain access to the internal scoreboard components, simply remove the three screws securing
the back panel to the scoreboard cabinet, and swing it open. Drawing A-159887 in Appendix
A illustrates the back panel open and all of the internal components exposed.
Note: Disconnect power before servicing the scoreboard! Also turn power OFF when the
scoreboard is not in use. In addition to discharging the scoreboard batteries, prolonged
power-on may shorten the life of some electronic components.