Daktronics MS-2013 Portable LED Scoreboard - Manual (Page 11)

Mechanical Installation 5
Section 3: Mechanical Installation
Mechanical installation involves assembly of the cart. The scoreboard itself requires no assembly or
permanent installation. Some assembly is required, however, for certain scoreboard options.
3.1 Cart Assembly
Reference Drawings:
Mechanical Specifications, MS-2013 .................................................................... A-159886
Cart Assembly ....................................................................................................... A-159889
The display cart, as shown in Figure 4, comes standard
with two wheels, but may use four if ordered. Open the
cart kit and verify the following pieces are included:
 T-stands @ 2
 Axle tubes @ 4
 10" wheels @ 2 (or 4)
 1 /
2
"-13 x 3 1 /
2
" bolts @ 2 (or 4)
 1 /
2
" flat washers @ 2 (or 4)
 5 /
16
" diameter pins with clips @ 6
A
3 /
4
" wrench will be needed to attach the wheels.
Refer to Drawing A-159889 in Appendix A and the
following instructions to assemble the cart:
1. Insert the axle tubes into the T-stands, and secure them with pins and retaining clips.
2. Mount the scoreboard by inserting the two T-stands into the larger tube attachments
on the sides of the scoreboard, and secure the stands with pins and retaining clips.
(The tubes mounted on either side of the scoreboard are permanent attachments; do
not remove them during cart disassembly.)
3. Mount the first wheel to one end of the T-stand, using a washer as a spacer, and
secure the wheel with an axle bolt. Repeat the process for the second wheel, and
tighten the bolts with a
3 /
4
" wrench.
Note: Two more optional wheels may be installed on the opposite T-stand.
3.2 Adjusting the Cart
Drawing A-159886 in Appendix A shows the two axle positions that may be used with the
cart. The extended axle position provides maximum stability and is recommended for any
situation in which the scoreboard is raised. Use the narrow axle position (and lowest height)
to move the scoreboard through doorways and for storage. The drawing also illustrates front
profiles of the scoreboard in transport position and at maximum viewing height.
Figure 4: Cart Assembly, Side View