Cybex 625T Treadmill - Manual (Page 37)

3.
Press the ENTER key again to change transmitter type.
4. Press Quick Start to select your transmitter type from the available choices. The display will only
show choices available under your transmitter type (900 MHz, 863 MHz or 806 MHz).
806 MHz System 863 MHz System 900 MHz System
J1 806 Japan 14 channels M 863 MYE M 900 MYE
J2 806 Japan 30 channels E 863 Enercise C 900 Cardio Theater
A 863 Audeon E 900 Enercise
B 900 Broadcast Vision
5.
Press Scan/Hold or Display Option to scan for available channels. The scan can take
up to 10 seconds and then display CH 1 of #. The # symbol is total number of strong UHF channels
found. Some of these channels may not be signals from the TV transmitters and need to be deleted.
Review channels
1.
Press Up or Down to listen to available channels with the headphones.
2.
Delete unwanted channels by pressing Speed Up or Down to change the right LED window
to [dEL].
Press Enter to delete channel. Repeat process for additional unwanted channels.
3. Adjust the near/far setting if available channels are not showing.
Press Setup key to change the setting from F (Far) to n (Near). Press Display option to re-scan
for available channels.
4.
Press Up or Down to scroll through and verify all TV channels.
If all TV transmitters are stored, and they all correlate the TV number to the correct TV heard, setup
is complete. If not you may need to re-scan or adjust the transmitter codes (see documentation for
your transmitters to perform a code change).
5. Press STOP to exit setup. Transmitter setup complete.
6. Proceed to Add FM Radio Stations (optional).
Setup TV FM Transmitters
If your TV’s use FM transmitters, follow these instructions to assign a TV channel to each frequency.
1. Enter A/V setup mode.
2.
Select TV FM and press the ENTER key.
Page 37 of 88
Cybex 625T Treadmill Part Number LT-23221-4 H