Cybex 750C Cycle Bike - Manual (Page 48)

Cybex 750C/750R Cycle Owner’s Manual
48
Wireless Heart Rate Display – To use this feature, a Polar® compatible heart rate transmitter belt
(not included) must be worn.
Once the actual heart rate is determined, the LED to the right of the Text Area is blinking to the
displayed BPM and the Heart LED lights up. The color of the light represents a scale of low to high
target heart rate.
P-9 Heartrate Control P-8 Cardio P-7 Strength P-6 Interval P-5 Ramps P-4 Pike’s Peak P-3 Hills P-2 Rolling Hills P-1 Weight Loss
White Valid BPM not yet available
Blue 0 –
69 BPM
Green
70 – 93 BPM
Yellow 94 – 119 BPM (Fat Burn Zone)
Blood Orange
120 – 169 (Cardio Zone)
Magenta 170 and higher
Fan Control
The fan defaults at the “OFF” setting. The user can change to “LO” or “HI” setting by pressing the
appropriate control key. User must be pedalling for fan to operate.
Alarm Set
To set up an alarm to sound during workout:
1.
Press key #8 on the keypad, also labeled with an alarm clock icon. Text Area will display
“ALARM AT HH:MM Y”. Initially, this display reflects actual time.
2. Use keypad to enter a direct time. Press the ENTER key after each entry to accept and move
forward.
HH (Hour) MM (Minutes) Y=A (AM) or P (PM)
The LEVEL
key is also active to adjust the display value (up or down). Hold down key to accelerate
rate of increment.
Once alarm time occurs, the display will show “ALARM” and start beeping. Press the CLEAR, ENTER
or ALARM key to reset.
Battery Sentry
Battery Sentry uses display feedback (speed signal, key presses and heart rate) to determine user
presence. If a user is not detected within 20 seconds, the display beeps and inquires
“ARE YOU THERE?”.
Resume pedalling, grab the contact heart rate grips or press any key within a pre-selected time to
resume workout.