Contemporary Control Systems EXP Expansion Modules User Manual - Manual (Page 10)

2
Installation
2.1 Introduction
The MOD HUB can be either desktop mounted, panel mounted
or rack mounted. One model, the MODHUB-16F-N has its own
NEMA 1 enclosure for wall mounting.
2.2 Electromagnetic Compliance
The MOD HUB series complies with Class A radiated and
conducted emissions as defined by CFR
47 Part 15 and EN55022.
This equipment is intended for use in nonresidential areas. Refer
to the following notices in regard to the location of the installed
equipment.
Note: This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to Part 15
of the CFR Rules.
These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment.
This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications.
Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense.
Warning
This is a Class A product as defined in EN55022. In a
domestic environment this product may cause radio
interference in which case the user may be required to take
adequate measures.
TD401600-0M
O
6