Comtech EF Data RCU108 - Manual (Page 18)

Installation RCU108 1:8 Protection Switch
Page 2-8 TM066 - Rev. 1
2.4.4.4 Rear Panel Section B, Converter Number 4
J4 - IF Converter
This BNC/Female connector is routed from the IF connector (J2) of the RCU108 to J2 of
primary converter number 4. The connection is made through the IF cable assembly,
CA/3598, which is a supplied item.
J5 - IF In/Out
This BNC/Female connector is routed from the User IF connector of the RCU108 to the
User Interface.
J9 - RF In/Out
This SMA/Female connector is routed from the User RF connector of the RCU108 to the
User Interface.
J10 - RF Converter
This SMA/Female connector goes to the RF connector of the RCU108 to the Primary
Converter number 4 (J1). This connection is made through supplied RF cable assembly
CA/3602-4.
J15 - RF Backup Interface
This SMA/Female connector goes to the RF connector of the RCU108 to the RF
connector (J12) section C of the RCU108. The connection is made with RF cable
assembly CA/3602-U, a supplied item.
2.4.4.5 Rear Panel Section C, Converter Number 5
J2 - IF Converter
This BNC/Female connector is routed from the IF connector (J2) of the RCU108 to J2 of
primary converter number 5. The connection is made through the IF cable assembly
CA/3598 which is a supplied item.
J3 - IF In/Out
This BNC/Female connector is routed from the User IF connector of the RCU108 to the
User Interface.
J7 - RF In/Out
This SMA/Female connector is routed from the User RF connector of the RCU108 to the
User Interface.
J8 - RF Converter
This SMA/Female connector goes to the RF connector of the RCU108 to the Primary
Converter number 5 (J1). This connection is made through supplied RF cable assembly
CA/3602-5.
J13 - RF Backup Interface