Comtech EF Data CPLINK - Manual (Page 20)

18
Appendix A
Menu Bar Options
1. Communications Setup:
Menu Bar Icon > Options >Communications
Note: The Menu Bar is accessed on the Palm

m500 and other models by tapping the pointer
on the fixed menu bar icon / button in the
bottom left corner (just to the left of the abc-dot
area) of the Palm
 device. Some Palm
devices allow the upper black bar to be tapped
to drop down the options menu.
Baud Rate: The Baud Rate can be manually
set to 1200, 2400, 4800, 9600, or 19200.
XCVR Address: The XCVR address can also
be set manually from 1-999.
If the Baud Rate and / or XCVR Address is not
known, the CPLINK software can locate the
connected XCVRs.
(Find XCVR) button – The found XCVR will
be set to address #1 and the redundant XCVR (if
applicable) will be set to address #2.
(OK) button – The displayed baud rate and
address information are programmed into the
Palm
.